[Dec 15, 2023] Passing Key To Getting 300-730 Certified Exam Engine PDF [Q92-Q108]

4/5 - (1 vote)

[Dec 15, 2023] Passing Key To Getting 300-730 Certified Exam Engine PDF

300-730 Exam Dumps Pass with Updated Dec-2023 Tests Dumps

Prerequisites

The intended audience for this exam is Channel Partners, Network Security Engineers, and CCNP Security Candidates, among others. The Cisco 300-730 test does not have any compulsory requirements. However, the applicants should have knowledge of different Cisco router and firewall command modes. Moreover, it is pretty important to possess expertise in managing Cisco routers and firewalls. In addition, the candidates have to be familiar with the advantages of site-to-site and Remote Access VPN options. They can get and master the necessary skills through completing such courses by Cisco as CCNA and SCOR.

NEW QUESTION 92
Refer to the exhibit.

Which type of Cisco VPN is shown for group Cisc012345678?

Cisco AnyConnect Client VPN

DMVPN

Clientless SSLVPN

GETVPN

NEW QUESTION 93
A network engineer must design a clientless VPN solution for a company. VPN users must be able to access several internal web servers. When reachability to those web servers was tested, it was found that one website is not being rewritten correctly by the ASA. What is a potential solution for this issue while still allowing it to be a clientless VPN setup?

Set up a smart tunnel with the IP address of the web server.

Set up a NAT rule that translates the ASA public address to the web server private address on port 80.

Set up Cisco AnyConnect with a split tunnel that has the IP address of the web server.

Set up a WebACL to permit the IP address of the web server.

NEW QUESTION 94
Which redundancy protocol must be implemented for IPsec stateless failover to work?

SSO

GLBP

HSRP

VRRP

NEW QUESTION 95

Refer to the exhibit. A site-to-site tunnel between two sites is not coming up. Based on the debugs, what is the cause of this issue?

An authentication failure occurs on the remote peer.

A certificate fragmentation issue occurs between both sides.

UDP 4500 traffic from the peer does not reach the router.

An authentication failure occurs on the router.

NEW QUESTION 96
Which clientless SSLVPN supported feature works when the http-only-cookie command is enabled?

Citrix load balancer

port reflector

Java rewriter –

Java plug-ins

script browser

NEW QUESTION 97
Refer to the exhibit.

Based on the debug output, which type of mismatch is preventing the VPN from coming up?

interesting traffic

lifetime

preshared key

PFS

NEW QUESTION 98
In a FlexVPN deployment, the spokes successfully connect to the hub, but spoke-to-spoke tunnels do not form. Which troubleshooting step solves the issue?

Verify the spoke configuration to check if the NHRP redirect is enabled.

Verify that the spoke receives redirect messages and sends resolution requests.

Verify the hub configuration to check if the NHRP shortcut is enabled.

Verify that the tunnel interface is contained within a VRF.

NEW QUESTION 99
A network engineer is setting up a clientless SSLVPN on a Cisco ASA. Remote users must be able to access an internal webserver via the URL example.com. Which two steps accomplish this task? (Choose two.)

Configure a bookmark for the webserver.

Configure routing so that the user’s computer can reach the webserver.

Configure a DNS server that can resolve the webserver URL.

Configure a browser plugin on the Cisco ASA.

Configure routing so that the Cisco ASA can reach the webserver.

NEW QUESTION 100
Refer to the exhibit.

Which two conclusions should be drawn from the DMVPN phase 2 configuration? (Choose two.)

Next-hop-self is required.

EIGRP neighbor adjacency will fail.

EIGRP is used as the dynamic routing protocol.

EIGRP route redistribution is not allowed.

Spoke-to-spoke communication is allowed.

NEW QUESTION 101
An engineer is building an IKEv1 tunnel to a peer Cisco ASA, but the tunnel is failing. Based on the configuration in the exhibit, which action must be taken to allow the VPN tunnel to come up?

Add a route for the 10.7.7.0/24 network to egress the outside interface.

Enable IKEv1 on the outside interface.

Change the IKEv1 policy number to be at least 256.

Change the transform set mode to transport.

NEW QUESTION 102
Which feature allows a DMVPN Phase 3 spoke to switch to an alternate hub when the primary hub is unreachable?

multicast PIM

backup NHS

per-tunnel jitter probes

NHRP shortcut

NEW QUESTION 103
Refer to the exhibit.

An SSL client is connecting to an ASA headend. The session fails with the message “Connection attempt has timed out. Please verify Internet connectivity.” Based on how the packet is processed, which phase is causing the failure?

phase 9: rpf-check

phase 5: NAT

phase 4: ACCESS-LIST

phase 3: UN-NAT

NEW QUESTION 104
Refer to the exhibit.

Client 1 cannot communicate with client 2. Both clients are using Cisco AnyConnect and have established a successful SSL VPN connection to the hub ASA.
Which command on the ASA is missing?

dns-server value 10.1.1.2

same-security-traffic permit intra-interface

same-security-traffic permit inter-interface

dns-server value 10.1.1.3

NEW QUESTION 105
Which two commands help determine why the NHRP registration process is not being completed even after the IPsec tunnel is up? (Choose two.)

show crypto isakmp sa

show ip traffic

show crypto ipsec sa

show ip nhrp traffic

show dmvpn detail

NEW QUESTION 106
An engineer is requesting an SSL certificate for a VPN load-balancing cluster in which two Cisco ASAs provide clientless SSLVPN access. The FQDN that users will enter to access the clientless VPN is asa.example.com, and users will be redirected to either asa1.example.com or asa2.example.com. The cluster FQDN and individual Cisco ASAs FQDNs resolve to IP addresses 192.168.0.1, 192.168.0.2, and 192.168.0.3 respectively. The issued certificate must be able to be used to validate the identity of either ASA in the cluster without returning any certificate validation errors. Which fields must be included in the certificate to meet these requirements?

CN=*.example.com, SAN=asa.example.com

CN=192.168.0.1, SAN=asa1.example.com, asa2.example.com

CN=asa.example.com, SAN=asa.example.com, asa1.example.com, asa2.example.com

CN=192.168.0.1, SAN=192.168.0.1, 192.168.0.2, 192.168.0.3

NEW QUESTION 107
Which parameter must match on all routers in a DMVPN Phase 3 cloud?

GRE tunnel key

NHRP network ID

tunnel VRF

EIGRP split-horizon setting

NEW QUESTION 108
What is a requirement for smart tunnels to function properly?

Java or ActiveX must be enabled on the client machine.

Applications must be UDP.