Pass JN0-682 Exam Latest Practice Questions Updated on Feb 27, 2023 [Q20-Q40]

Rate this post

Pass JN0-682 Exam Latest Practice Questions Updated on Feb 27, 2023

Juniper JN0-682 Study Guide Archives

NEW QUESTION 20
Which two statements are correct about VXLAN domains? (Choose two.)

With Layer 2 traffic, the VLAN ID is discarded before the packet is sent.

With Layer 3 traffic, the VLAN ID is discarded before the packet is sent.

With Layer 2 traffic, the VLAN ID is transmitted within the packet.

With Layer 3 traffic, the VLAN ID is transmitted within the packet.

NEW QUESTION 21
You choose the EBGP design shown in the exhibit as your IP fabric design. You must ensure that both routes received by the spine nodes will be used for ECMP forwarding.
Which BGP parameter would need to be added to the EBGP configuration of the spine nodes to achieve this goal?

multipath

multihop

add-path

multipath multiple-as

NEW QUESTION 22
A client with five data centers spread around the country uses MPLS L2VPNs to provides point-to-point data
center interconnect between each data center in a full-mesh network. The client Is considering an MPLS
EVEN implementation.
In this scenario, what are three advantages of using MPL5 EVEN interconnects? (Choose two.)

The provide for static configuration that does not require a Dynamic Routing Protocol

They provide for a local proxy ARP/ND resolution.

They provide for point to multipoint connectivity

They provide for a MAC learning in the control plane.

They provide for lower transmission latency.

NEW QUESTION 23
You are an engineer for a hosting company. You have a new customer that wants the ability to connect any VLAN on any port. They want to have all VLANs map to a single bridge domain and EVPN instance (EVI).
They control all their own routing and just need the connectivity.
Which two parameters should you configure to achieve these goals? (Choose two.)

instance-type mac-vrf

service-type vlan-aware

service-type vlan-bundle

instance-type virtual-switch

NEW QUESTION 24
Exhibit.

You are attempting to configure filter-based forwarding in your data center. All traffic from Host1 that is going to Host2 should be inspected by the data center firewall. You have verified that the traffic is being forwarded from router leaf L1’s VRF-1 to its INSPECT-VRF. however, the traffic is not reaching service L2.
Referring to the exhibit, which two steps should you take to troubleshoot the problem? (choose two.)

Examine the INSPECT-VRF.evpn 0 route table on L1 for a default route that will direct the traffic to L2.

Examine the INSPECT-VRF.inet. 0 route table on L1 for a default route that will direct the traffic to L2.

Ensure that VRF-1 and INSPECT-VRF route targets on L1 and L2 match.

Ensure that the route target in the INSPECT-VRF of L1 matches the route target of the INSPECT-VRF of L2.

NEW QUESTION 25
What are two streaming data formats supported for network analytics? (Choose two.)

GPB

XML

JSON

SLAX

NEW QUESTION 26
Exhibit.

The configuration shown in the exhibit is intended to set up assisted replication but will not commit.
Which action will create a valid configuration in this situation?

Change the 10.0 address to 192.168.100.1 primary.

Change the replicator inet address to 192.168.100.101.

Delete replicator inet 192.168.100.1.

Change the replicator inet address to 192.168.100. 51.

NEW QUESTION 27
Exhibit.

An EVPN-signaled VXLAN overlay has been deployed in the network shown in the exhibit. An EVPN LAG has been configured to connect host1 to the network, and device leaf1 has been elected as the designated forwarder. In this scenario, which statement is true?

The Ieaf3 device can utilize both leaf1 and Ieaf2 to forward unicast packets from host2 to host1.

An ICCP control link must be configured between leaf1 and Ieaf2.

The Ieaf3 device will only receive an advertisement to the LAG segment from leaf1.

Broadcast packets sent from host2 will not be forwarded to Ieaf2.

NEW QUESTION 28
You need to add perimeter security to the network shown in the exhibit. All traffic must be inspected for attacks. The edge routers are using all available ports. Your solution must maintain both port and device resiliency.

In this scenario, which design would satisfy these requirements?

one-arm SRX Series chassis cluster

one-arm SRX Series device using LAG

inline SRX Series chassis cluster

inline SRX Series device using LAG

NEW QUESTION 29
Referring to the exhibit, DC1 and DC2 have a DCI across a service provider WAN connection.
Host1 in DC1 must have Layer 2 connectivity to host2 in DC2. A VXLAN tunnel must be created between VTEP1 and VTEP2.
In this scenario, which statement is true?

A route to the loopback address on VTEP must be present on VTEP1.

VTEP and VTEP2 must peer using IBGP.

VXLAN Layer 3 gateway must be provisioned at the Super Spine layer.

The service provider WAN connection be an MPL5-based WAN connection.

NEW QUESTION 30
You want to enable an EBGP-based IP fabric to allow ECMP routes to be populated into the RIB.
In this scenario, which action will accomplish this task?

Enable the forwarding-options ecmp-do-local-lookup parameter.

Enable the multipath multiple-as BGP parameter.

Enable the routing-options multipath global parameter.

Enable the chassis ecmp-alb parameter.

NEW QUESTION 31
You are troubleshooting an L3VPN that is part of an EVPN/MPLS DCI. You notice that the EVPN overlay BGP session toward 10.29.50.4 is unable to establish.

Why is the BGP session failing to establish?

The route-distinguisher value on the local PE is incorrect

There is no route for 192.168.5.5 an VPN net 0.

There is no route for 192.168.5.5. in inet 3.

The vrf-table label value is not configured in the remote PE.

NEW QUESTION 32
After configuring an IP fabric using EBGP as you protocol, you notice that not all of the routers are showing
up in the routing tables. You have verified that all adjacencies have formed, and place and configured
properly.
In this scenario, which statement is true?

The routers have not been configured with the multipath multiple-as parameter.

The routers have not been configured using the bfd-1 Liveness-detection parameter.

The routers have not been configured using the multihop parameter.

The routers have not been configured using the add-path parameter

NEW QUESTION 33
Exhibit.

Referring to the exhibit, which two statements are correct? (Choose two.)

There are two tunnels to the remote endpoint.

The irb. 0 interface is the remote tunnel endpoint interface.

The source tunnel IP address is 192.168.100.11.

There is one tunnel to the remote endpoint.

NEW QUESTION 34
Which two statements describes an IP fabric? (Choose two.)

Each leaf should have a connection to each spine.

Open standards allow for vendor interoperability.

Traffic should always follow a single path

xSTP protocols should be used to prevent loops

NEW QUESTION 35
The two data centers shown in the exhibit need to be connected using EVPN.
Which two statements are correct in this situation? (Choose two.)

Hosts in VLAN 10 can communicate with hosts in Data Center 2 using Layer 3.

Hosts in VLAN 10 can communicate with hosts in Data Center 2 using Layer 2.

Hosts in VLAN 202 can communicate using Layer 3 between data centers.

Hosts in VLAN 202 can communicate using Layer 2 between data centers.

NEW QUESTION 36
You are deploying a VXLAN using signaling overlay network in your new data center. You are able to
establish your MP BGP peering session and see your EVPN routes, but traffic will not traverse the VXLAN
using signaling overlay network.
What is a solution to this problem?

Enable the mtu-discovery feature on the MP peering sessions between VXLAN ANs EVPN signaling
peers.

Increase the protocol MTU on all devices participating in VXLAN using EVPN signaling

Increase the MTU on the logical VTEP source interface of all devices participating in VXLAN using
EVPN signaling.

Increase the physical MTU on all ports on all devices participating in VXLAN using EVPN signaling.

NEW QUESTION 37
Referring to the exhibit, Host 1 and Host 3 have exchanged traffic.

`
In this scenario, which statement is true?

Leaf 2 learn Host 1’s MAC address through periodic updates from Spine 2

Leaf 2 learn Host 1’s MAC address when Host 3 learns Host 1’s MAC address.

Leaf 2 learn Host 1’s MAC address when Leaf 1 queries Host 1.

Leaf 2 does not learn Host 1’s MAC address until Host1 and Host2 send traffic to each other

NEW QUESTION 38
Referring to the VTEP output shown in the exhibit, which two statements are true? (Choose two.)

The MAC address 52:54:00:2c:4b:a2 belongs to a local host.

The MAC address 52:54:00:5e:88:6a belongs to a remote host.

The MAC address 52:54:00:2c:4b:a2 belongs to a remote host.

The MAC address.52:54:00:5e:88:6a belongs to a local host.

NEW QUESTION 39
Referring to the exhibit, DC1 and DC2 have a DCI across a service provider WAN connection. Host1 in DC1 must have Layer 2 connectivity to host2 in DC2. A VXLAN tunnel must be created between VTEP1 and VTEP2.

In this scenario, which statement is true?

A route to the loopback address on VTEP must be present on VTEP1.

VTEP and VTEP2 must peer using IBGP.

VXLAN Layer 3 gateway must be provisioned at the Super Spine layer.

The service provider WAN connection be an MPL5-based WAN connection.

NEW QUESTION 40
You are asked to implement a monitoring and telemetry solution for the QFX Series devices in your IP fabric that uses a push model to collect both system event data and statistical data for your QFX Series devices.
Which technology satisfies your requirements?

JunosXMLAPI

REST API

SNMP

Junos Telemetry Interface