Get The Important Preparation Guide With H35-460 Dumps [Q57-Q81]

NEW QUESTION 57
Where is the downlink data distribution in the NSA architecture implemented?

NEW QUESTION 58
In the Sub 3G band, the maximum beam number of SSBs in the NR is 16.

NEW QUESTION 59
The gNodeB implements X2 self-configuration through the MME.

NEW QUESTION 60
The same frequency neighbor in the gNodeB station only needs to execute the MML command ADD RCELLRELATIOG to add.

NEW QUESTION 61
Which of the following requirements is included in the target rate of 5G eMBB scenarios?

NEW QUESTION 62
Regarding the NR physical layer processing, which of the following description is wrong?

NEW QUESTION 63
Which of the following MML commands is used to add the gNodeB identifier?

NEW QUESTION 64
What are the subcarrier spacings supported by the 5G RAN2.0 gNodeB cell? (Multiple choice)

NEW QUESTION 65
QoS of gNB implements hierarchical congestion management of services by mapping DSCP values.

NEW QUESTION 66
5G RAN 2.0 version gNodeB adds which MML command is used in DU cells?

NEW QUESTION 67
Which of the following bands is not included in the candidate SUL spectrum for uplink and downlink decoupling in the C-band?

NEW QUESTION 68
Under NSA networking, which of the following commands can be used to check whether the S1-U interface is normal?

NEW QUESTION 69
What is the maximum output power of the AAU5613?

NEW QUESTION 70
What is the MML command used by gNodeB to add CI port configuration?

NEW QUESTION 71
NSA networking needs to modify the original EPS, in addition to adding NR base stations, what upgrades need to be made?

NEW QUESTION 72
Where is the downlink data distribution in the NSA architecture implemented?

NEW QUESTION 73
Which entity is the RLC layer used for detection and error correction?

NEW QUESTION 74
Which MML command is used to add MCC and MNC information to gNodeB?

NEW QUESTION 75
The gNodeB sector is deployed using the AAU5613. What is the maximum value of single-cell transmit power configuration?

NEW QUESTION 76
What are the following layer two protocol of the 5G air interface control plane? (Multiple Choice)

NEW QUESTION 77
When the gNodeB is enabled with the MassiveMIMO function, select “Beam” in the “Antenna Configuration Mode” in the sector device parameters.

NEW QUESTION 78
Considering compatibility, the BBU5900 chassis supports all BBP series boards of LTE.

NEW QUESTION 79
What is the recommended eCPRI connection bandwidth for the 100Mhz 64T64 cell?

NEW QUESTION 80
Which of the following MML commands do you need to perform to add neighbor information across the gNodeB? (Multiple choice)

NEW QUESTION 81
In the GL to GL+NR (BBU39XO+BBU5900) evolution path, which of the following devices does not need to be added?